Hantek Hantek2D82Auto - Automatic Measurement and Utility Settings; Automatic Measurement Types

17
5. The result of cursor measurement will be displayed on the cursor menu.
Automatic Measurement
The oscilloscope provides 2 kinds of automatic measurements, including frequency and
amplitude.
Press button to enter, select Measure to enter automatic measurement. Press F1
to open, the measurement results will be displayed on the top left corner of the screen.
Measurement Menu Table
Menu
Description
Frequency
Measure the frequency of the signal.
Maximum
Voltage
Measure the maximum voltage of the signal.
Minimum
Voltage
Measure the minimum voltage of the signal.
Attention:
In the measurement result, the yellow font is the result of CH1, and the green font is the
result of CH2.
Utility
Press button to enter.
Utility Menu Table
Menu
Setting
Description
Language
中文
English
Set the menu language.
Sound
On
Off
Open the key sound.
Close the key sound.
Backlight
luminance
1~10
Set backlight brightness of the screen.
Backlight
time
30s
60s
90s
120s
Unlimited
Set the screen backlight time.
System
information
Display system information, such as software
version or PCB version.