28
Output the arb waveform
1. Install the software
Download the latest software on the official website, double click Setup.exe to install.
The link is as follows:
http://hantek.com/en/ProductDetail_13_16175.html
2. Double-click the Hantek2xx2 icon to open the software and select "DDS" in the right
control bar to enter the signal generator control bar.
3. Put "√" in the box in front of "on/off" to open the signal output.
4. Select "signal type" as "arb", and set the corresponding frequency and amplitude;
5. Select "Arb Channel" as Arb1/Arb2/Arb3/Arb4. Each arb channel can save only one
arbitrary waveform which was downloaded last time. Turn on again after shutdown,
and automatically recall.
6. Draw arbitrary waves in waveform area with mouse.
7. Connect Gen Out connector to oscilloscope for observation.
To Next Page
Loading...
