Hantek HT2018B - Print Test Report

HT2018B(C) Battery System Tester 12
◆ If the voltage is greater than 15.0V (for 6V system, the voltage is greater than 7.50V;
for 24V system, the voltage is greater than 30.00V), please check the voltage
regulator.
◆ If the voltage is less than 13.3V (for 6V system, the voltage is less than 6.6V; for 24V
system, the voltage is less than 26.60V), please check the connection point, wire
and dynamotor.
Data reference table (12V system)
status
Battery voltage
engine performance
No headlight and air
cooler
(need to step on the
accelerator to test)
Above 13.5
Normal
13.2~13.5
Common
13.0~13.2
Attention
Below 13
Need to examine and
repair immediately
Turn on headlight
and air conditioner
(need to step on the
accelerator to test)
13.4~14.6
Normal
13.2~13.4
Common, attention
Below 13.2
Need to examine and
repair immediately
The above data are for reference. If there is any problem of battery, the
data will also be affected.
5.6 Print Test Report
HT2018C battery tester has the kinetic energy to print test report, for recording and
checking test results. You need to connect with the Bluetooth printer to the tester for print.
Note: Bluetooth printer is optional, the user can purchase from our company or find other
ways to buy.
The matching printer models are: XINYE XP-58IIH Bluetooth printer and Hejie XM-
NAP-1 CB58B Bluetooth printer.
Operation:
1) After the instrument test in battery startup test, the screen stays at the following
interface.
2) Now press the middle button to enter the inquiry “Print the test report?” Press the
<ENTER> button to print or press the <ESC> button to exit.
RESULT GOOD
12.87 V 588 CCA
100% 4.75 mΩ
SOH 100 %