To Next Page

To Previous Page

FAN MOUNTING

Depending on the length of downrod you use, you

may need to cut the lead wires back to simplify the

wiring. If you decide to cut back the lead wires, it is

suggested you do so in the following manner:

Take the lead wires and make sure you have pulled

them all the way through the top of the downrod.

Start at the TOP of the ball on the downrod and

measure 8 in. of lead wire, and then cut the excess

wire off with wire cutters (not included).

NOTE: If you do not cut back the lead wires, Steps

4 and 5 are not necessary and you may proceed

to Step 6 instead.

Slip downrod (A) into yoke, align holes and

re-install pin (P) and clip (Q). Tighten set screws

and then tighten nuts on the set screws. Slide

yoke cover (E) down until it rests on top of motor

housing (G).

Lowes.com/harborbreeze

If you decided to cut back the lead wires in Step 4,

strip a 1/2 in. of insulation from end of WHITE wire.

Twist stripped ends of each strand of wire within the

insulation with pliers (not included). Repeat Step 5

for BLACK, BLUE (if applicable) and GREEN wires.

Ball

8 in.

Set Screws

and Nuts

Yoke

Harbor Breeze TEX52MBK5C1L User Manual

Questions and Answers: