Hardi MEGA 230 - Lubrication of Chain & Sprocket; Greasing the Breakaway Clutch

54
HARDI MEGA 230 / 350 CENTRIFUGAL OPERATORS MANUAL
7.6Lubrication of Chain and Sprocket
Every 25 hours the chain and sprocket at the hinge point of the interme-
diate and outer wing sections should be lubricated with a chain lubricant.
7.7 Greasing the Breakaway Clutch
NEVER PLACE FINGERS INTO OPEN BREAKAWAY CLUTCH OR
YOU MAY BE INJURED SHOULD CLUTCH SNAP CLOSED.
1. Unfold the boom into spray position.
2. Standing in front of the outer wing, snap the breakaway open by
quickly pushing the boom away from you.
3. With the two clutches opened up, stick the nozzle of grease gun into
the clutch and apply a generous amount of grease. This should be
done every 8 hours. (Refer to fig. 34)
4. Apply oil to top of breakaway section hinge to lubricate bushing.
Fig. 34
40 Hrs
40 ft/lbs
55 N•m
A. RETORQUE FASTENERS
8 Hrs
B. GREASE
B
A
105192