Harman Super Magnum Coal Stoker - Leveling the Appliance; Optional Heat Transfer Kit; Air Filter; Optional Decorative Tile Kit

17
Do Not Burn Wet Coal!
Super-Magnum Coal Stoker Stove
3-90-02702R8_11/13
B. Leveling the Appliance
Toadjustthelevelingbolts,youmustrstloosenthelocking
nut. Turn the leveling bolt to the desired position, and re
tightenthelockingnutagainstthecastironleg.

The duct piping must be of metal construction in
accordance with NFPA 90B, 2-1.1, and 2-1.3.
1. Lift and remove the round cover from the top of the
SuperMagnum.
2. Install the 6" duct pipe starting collar into the round
opening. Reaching down through the starting collar,
bendthetabsupwardtosecurethecollartothestove.
3. Attachyour6"duct,comingfromaheatregisterlocated
a minimum of 17 ft.away,tothestartingcollar.Secure
the duct to the starting collar with a minimum of three
screws.
4. Maintain a minimum of 1" clearance to combustible
materialswiththeentirelengthofduct.
5. Ifmaximumheattransfertotheductisdesired,replace
the air grill, from the front of the stove, with the cover
platefromthekit.(SeePage18)
FOR YOUR SAFETY-At17to21feetofductlength,the1/2
inchtabMUSTberemovedfromthetopoftheplate.At21
feetormore,thecoverplatecanremainsolid,allowingall
oftheheatedairtoowthroughtheductpipe.
D. Air Filter
To ensure cleanliness of the air circulated through the
heat exchange, the Super Magnum is equipped with a
replaceable lter. The lter is located under the stove.To
removethelter,loosenthetwothumbscrewsandremove
thecover.Slidethelterouttheopenslotsinthefrontof
the channel.
Checkthelterfordamage,changeifnecessary.
ReplacementlterscanbeobtainedthroughyourHarman®
dealer,orfrommosthardware,orbuildingsupplycenters.
Besuretoturnthebloweroffpriortochanging

To install the optional ash door tile, you'll rst need to
unassembletheashdoor.
1. Laytheashdoor,facedown,onaatworkspace.
2. Remove thefourscrews whichholdthe llerplateinto
the door.
3. Laythellerplateandscrewsaside,andlaythetileinto
place on the door assuring that the tile is centered on
thegasket.
4. Applytheselfadhesivegasketontothebacksideofthe
tile.
5. Withthellerplateippedoverfromitsoriginalposition,
itnowbecomesthebackerforthetile.Attachusingthe
four screws.
Break-away tab for duct
lengths between 17 &21 feet.
Do not connect this appliance to the supply duct of an
existing furnace. This option is intended for use with a
single heat register.
Thumb Screws
Filter Cover
Filter
3-43-02730 ASH DOOR TILE
3-30-3110240382
BHSCS 10-24 X 3/8"
AD FILLER PLATE
3-44-11862 3/8" GASKET W/PSA
ASH DOOR