Harman Super Magnum Coal Stoker - Optional Door Trim Kit; Room Sensor Installation

18
Super-Magnum Coal Stoker Stove
Do Not Burn Wet Coal! 3-90-02702R8_11/13

The door trim kit includes a brushed stainless frame for
eachdoor,andanairgrill.Toinstalltheoptionaldoortrim,
you'll rst need to remove the latch mechanism from the
door.Theprocessisthesameforeachdoor.
1. Using a hex key wrench, loosen the set screw at the
latch.Removethelatchpinandlatchhandle.
2. Removethedoorfromstove.Laythedoorfacedownon
asoftmaterial.
3. Locatethefourdrilldimplesontheinsidecornersofthe
door.Usingbitsupplied(1/4”),drillaholethrougheach
corner.(twolocationsonashdoor)
4. Insertthedoortrimstudsthroughtheholes.Usinganut
driver, secure with the supplied nuts. These nuts are
placed on the stud with the indented triangle side facing
up. Before tightening the nuts, check that the frameis
properlynestedintotheoffsetofthedoor.Donotover-
tightennuts.Theframemaydistortorthestudcanbreak
loosefromtheframeifover-tightened.
5. Place door back on the stove. Attach the latch by
reversingStep1.
To Install the air grill, remove the existing painted grill.
Then, using the same two screws and spring washers,
installthebrushedstainlessgrill.
G. Room Sensor Installation
Although not required, it is recommended that the room
sensorbeconnectedineveryinstallation.Usingaminimum
size18gaugewire,youmayspliceinanadditionallength,to
extendtheroomsensor.Thefollowingaretypicallocations
fortheroomsensor;
• On an interior wall next to or in place of a typical wall
thermostat.
• Onthelegofacoffeetableorendtableinyourfavorite
sitting location.
• Dangledbehindthestove,hiddenfromview,actingasa
return air sensor.
Note: When installing the room sensor, limit the
distance from the stove to 25 feet or less.
Oncethelocationhasbeendecided,runthewiringtothe
rearofthestove.Crimpthetwofemaleterminalsontothe
endsofthewiresandplugthemintotheportprovidedon
the right rear portion of the stove. These connections are
notpolarityspecic.
Note: If the room sensor is located too close to the
appliance, or in a direct path of the distribution air, You
may need to elevate the temperature setting to maintain
a comfortable temperature level throughout the heated
space.
RoomSensor
attaches on
rear of stove.
SetScrew
Lockingnuts