EasyManua.ls Logo

Harman Super Magnum Coal Stoker - Motor and Component Servicing

Harman Super Magnum Coal Stoker
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Super-Magnum Coal Stoker Stove
Do Not Burn Wet Coal! 3-90-02702R8_11/13
28
8. Chimney Connector
 Frequency:Asnecessary/Yearly
 By:QualiedServiceTechnician/User
Attheendoftheburnseason,brushandcleanallsections
of chimney connector pipe. Some owners remove the
chimneyconnectorfortheoffseason.Anycoalashesleft
in the connector pipe will actually draw moisture which
promotesrust.Thisiswhyitisveryimportanttoclean all
ashes at the end of the heating season.
9. Chimney
 Frequency:Asnecessary/Yearly
 By:QualiedServiceTechnician/ChimneySweep
The entire chimney should be professionally cleaned at
leastonceyearly.Itisbesttohavethisdoneattheendof
theheatingseasontobesureallashisremoved.You'llalso
wanttoinspecttheconditionofthechimneypriortousing
theappliance,tobesuretherearenobirdnestsorthelike.
D. Motors and Components
1. Feed Motor
Requiresnolubrication.
Keepthemotorwindingsfreeofdust.Canbewipedclean
orvacuumed.
Toremovefeedmotor;
• Removerearaccesspanelandopenleftreardoor.
• Removefeedshaftshieldbypushingwiththumbwhere
shown,andliftupwhilepullingout.
SetScrew
MountingScrews
2. Combustion Blower
Requiresnolubrication.
Keepthemotorwindingsandintakescreenfreeofdustand
pethair.Canbewipedcleanorvacuumed.
Toremovecombustionblower;
• Openleftreardoor.
• Removewire-tiefromblowerpowercord.
• Slide the blower mounting ange out of the bracket
toward the left side.
NOTICE: When re-installing blower, be sure it is slid
completelyintothemountingbracket.Thereisastoponthe
rightsideofthebrackettoensureproperpositioning.
BlowerMountingBracket
• LocatetheAllen-headsetscrewonthefeedmotorshaft
and loosen it.
• Removethe4motormountingscrewsandpullthemotor
outthroughtheleft,reardoor.

Related product manuals