22
Super-Magnum Coal Stoker Stove
Do Not Burn Wet Coal! 3-90-02702R8_11/13
C. Before Your First Fire
• Be sure the appliance is installed properly and that
allsafetyrequirementshavebeenmet.Payparticular
attention to the clearances to combustibles, oor
protection and the venting instructions.
• Testyoursmokedetector(s)andCOdetector(s)tothe
specicationsofthemanufacturer.
• Doublecheckthattheashpanandinternalreboxare
empty.
• Besuretoreadthisentiremanual.
D. Starting Your First Fire
1. With the mode selector in the "OFF" position, and the
FeedAdjusterNOTon"Test",plugthepowercordintoa
properly grounded receptacle.
2. FillthehopperwithDRYcoal.
3. Place somecoalon the burn grate, llingthevalley in
theback.
4. Turnthemodeselectordialtothedesiredmode.If Room
Temp is selected, be sure to turn the temperature
dial above the current room temperature.
5. Filltherestofthegrateswithamixtureofwoodpellets,
ricecoal,andstartinggel.
6. Lightthestartinggelwithamatch,andclosethedoor.
7. OnlyaftertheESPtemperatureincreases,willthefeeder
startoperatingtoincreasetheresize.
NEVER APPLY STARTING GEL TO THE STARTING
MIXTURE WITHOUT THE COMBUSTION BLOWER
OPERATING.
"NEVER USE GASOLINE, GASOLINE-TYPE
LIGHTER FLUID, OR SIMILAR LIQUIDS TO
START OR "FRESHEN UP " A FIRE IN THIS
AWAY FROM THE HEATER WHILE IN USE".
E. Fire Characteristics
Afterlightingthere,itwillgothroughafewdifferentstages
ofappearance.First,becauseofthewoodpelletsmixedin,
you'llseemostlytallyellowames.Asthewoodpelletsburn
away,andsomecoalbeginstoignite,youryellowameswill
shortenandmixwithblueames.Afterthewoodpelletsare
goneandthecoalistheonlythingburning,you'llseemostly
blueames,whichcanbeinvisibleinabrightlylitarea.As
theresettlesin,you'llhaveaboutatwoinchbandofhot
burningcoalsrunningacrossthegrates.Withamaximum
temperature demand, the ideal feed rate setting will put
this band approximately 1-2 inches back from the end of
the grates. Allow at least an hour of burn time between
adjustmentstothefeedrate.
The setting above will produce continuous maximum heat output
with the distribution blower at full speed.
The setting above will produce continuous medium heat output with
the distribution blower at low speed.
WARNING