Outside Lifts - Installation & Owner’s Manual 2013
29
Section 2 : inStaller
Chair Preparation
Installing U-Bolt Hardware Kit
The U-bolts are used with power chairs or
scooters that do not have a center seat post. On
this type chair, the seat is normally attached to
a tubular frame. Install the U-bolts, two on each
side, to the frame as shown. [Figure 29-1]
Ensure that the loop extends to the outside of
the chair so the user can attach the strap hooks.
Figure 29-1
Each chair is slightly different so the U-bolt
placement will differ among models and
manufacturers. Place the U-bolts towards the
center of the seat if possible. Due to different
seat types, you may be forced to install the
U-bolts more towards the front or rear of the
seat, but we recommend attachment as close
as possible to the center of the seat.
To Next Page
Loading...
