HIGHLANDER II VERTICAL PLATFORM LIFTS: Install Manual
17FEB2021 | 630-00113 REV C
9
PREPARATION
HIGHLANDER II: SECTION 3
SECTION 3
PREPARATION
Installations may vary to some degree, but below
are the basic tools to have on hand for a Vertical
Platform Lift installation.
If you have any questions, concerns or comments,
please contact our Technical Service Department at
800-833-0478 or tech@harmar.com.
REQUIRED TOOLS AND
HARDWARE
• Tape Measure
• Grounding Strap
• Square
• Level
• Multimeter
• Wire Cutters, Wire Puller
• Stripper, Crimping Tool
• Hammer Drill
• "
• Wrench Set:
• "
• "
• "
• "
• Allen Wrench:
• "
• "
• "
• Torx Wrench
• T20
• No. 1 Phillips Head Screwdriver
• No. 2 Flat Head Screwdriver
• No. 2 Phillips Head Screwdriver
• Marking Implement
•
socket, extension and ratchet
• Concrete Drill Bits
• Temporary Power Means
• Precision Screwdriver Set
• Yellow / 74B wire Nut
• Anchors for Fixed Ramp (if specified)
RECOMMENDED TOOLS
• Work Lights (Wired or Wireless)
• Fish Tape
• Ladder
• Steel Toe Shoes
• Safety Glasses
• First Aid Kit
• Box Cutter
• Hard Hat
• Shop Vacuum
• Shop Towels and General Purpose Cleaner
To Next Page
Loading...
