Harmony V7 - Installing Cup Holder (When Applicable)

45
and unhook loops from plasc
base.
3. Gently slide fabric cover o the
backrest.
:
4. Locate elasc fabric loops (x2) and
snaps (x2) along base and detach
from child restraint.
5. Gently slide fabric cover o the plasc base from the
back of the child restraint towards the front of the
seat.

To reinstall fabric pads, repeat previous steps in reverse
order.
 For ease of fabric pad installaons, turn recline knob
counterclockwise to open gap at base of backrest to
facilitate passing the hook and loop tabs through
the gap to secure.
: Reinstall harness system if applicable (see
“Removing/Installing harness”, pg. 37).


1. Determine on which side you
would like the cup holder to be
installed. When installing child
restraint in a rear side seat, install
cup holder away from car door.
2. Locate the plasc protrusion on
either side of the child restraint
base.
3. Insert cup holder over plasc protrusion and pull
down unl locked into place.
4. Li to remove.