Harris Intraplex STL-160 Series - 5.2 User Interfaces

ACS-160 Series & STL-160 Series T1 Multiplexer Installation & Operation 5 – Remote Control
Version 2.11, August 2011
5-14 Harris Corporation
Intraplex Products
Then, when you click Submit, the fixed IP address is programmed into the module. You must reboot
the SCM-IP module before you can log on to the Web browser or Telnet using the new fixed IP
address.
The Intraplex SCM-1/SCM-IP Shelf Control Modules Installation & Operation Manual gives more
information on using the SCM-IP module and interface to configure and operate your ACS-160
Series/STL-160 Series multiplexer.
5.2 User Interfaces
You can access your multiplexer system using any of these Intraplex remote control methods:
● IntraGuide Configuration and Management Software
● SNMP via the SCM-IP module
● Intraplex Simple Command Language (ISiCL)
The next subsections discuss these methods.
5.2.1 IntraGuide Software
IntraGuide is a software program that gives you a simple method to review the status of the
multiplexer and change operational parameters. IntraGuide software allows you to
● Check system status visually.
● Interrogate for alarm conditions.
● Monitor and log hardware and communications links.
● Remotely configure your multiplexer system.
The program has an intuitive look and feel that meets the needs of both experienced technicians and
casual users. IntraGuide software also works offline. Configurations can be created in advance, saved,
and imported later.
5.2.1.1 Hardware Requirements
The IntraGuide software is designed to operate as an application under these operating systems:
● Windows NT
● Windows 2000
● Windows XP
● Windows Vista
You also need an available serial port. To use the IntraGuide network connectivity features, your PC
must be equipped with an Ethernet 10/100 BaseT network interface. A Super VGA (SVGA) display or
better is required. If your graphic display is set to 256 colors or less, you may experience occasional
color distortions and image flashing.
5.2.1.2 IntraGuide Access
To load IntraGuide software on your PC, run SETUP.EXE directly from the Intraplex User Manual
Library CD, which launches the setup program and prompts you through the remainder of the
installation process. You can also perform these steps to download this interface from the Harris BCD
Web site:
1. Go to
http://www.broadcast.harris.com.
2. On the navigation bar, click Services & Support | Client Support site for all Products.
3. Log on. (If you do not have an account, click New User and fill in the required information.)
4.
At Self Service, click Download Software Updates.