Harris Intraplex STL-160 Series - Figure 5-17. Change Channel Module Configuration by Remote Control

5 – Remote Control ACS-160 Series & STL-160 Series T1 Multiplexer Installation & Operation
Version 2.11, August 2011
Harris Corporation 5-37
Intraplex Products
Figure 5-17. Change Channel Module Configuration by Remote Control
Assume here that the password for the multiplexer is “BLUE.” Remember that all remote
communication with channel modules on a drop and insert shelf is through the DI-A CM-5RB
module. To unlock the remote port, type
7:DI-A:UNLOCK:BLUE;
The multiplexer responds
* OK;
To make the necessary changes, type
7:C4:SET:SRVC = OFF;
To verify the configuration of the channel module, type
7:C4:CONFIG?:;
Table 5-16 shows the system response.