4 – Setup & Configuration ACS-160 Series & STL-160 Series T1 Multiplexer Installation & Operation
Version 2.11, August 2011
Harris Corporation 4-5
Intraplex Products
Table 4-1. CM-5RB Basic Configuration Group (continued)
Group Selections Description
SIO Serial input and output settings (Section 5.1.1.3 – Configuration - Remote
Port Parameters (SIO Group) Setting)
RED = not selected, GREEN = selected
BAUD 110 Sets baud rate to 110 bps.
300 Sets baud rate to 300 bps.
1200 Sets baud rate to 1200 bps.
2400 Sets baud rate to 2400 bps.
4800 Sets baud rate to 4800 bps.
9600 Sets baud rate to 9600 bps.
19.2 Sets baud rate to 19.2 kbps.
57.6 Sets baud rate to 57.6 kbps.
PAR Spac Sets parity to space.
Mark Sets parity to mark.
Even Sets parity to even.
Odd Sets parity to odd.
exit Exit PAR and display Lock.
LOCK Locks and unlocks the serial port.
COMM Network communications parameters (Section 5.1.2 – DS0 Management
Communications)
CNFG OFF
(Default)
Turn network communications off.
MSTR Sets the multiplexer to master mode.
SLV Sets the multiplexer to subordinate mode.
BRDG Sets the multiplexer to bridge mode.
RATE 8 KB Sets the data rate to 8 Kbps (1 bit/DS0).
16 KB
(default)
Sets the data rate to 16 Kbps (2 bit/DS0).
32 KB Sets the data rate to 32 Kbps (4 bit/DS0).
64 KB Sets the data rate to 64 Kbps (8 bit/DS0).
TSLT 1 to 24 Time slot for T1 DS0 (time slot 24 is the default)
REDN
MRDN
LRDN
Common module redundancy settings – Only seen on redundant CM-5RB
common modules (Section 4.6 – Redundant CM-5RB (REDN Group))
Never switch to a backup.
On power-up, the 4-character display on the front panel indicates the multiplexing mode on the
primary CM-5RB module (Table 4-2). If a backup CM-5RB module is installed, it always reads BKUP
during power-up.
To Next Page
Loading...