MM-015371-001, Rev. C
58
8. Continue installation of the PTT switch by routing its small plug to the location near the round 8-pin
waterproof connector of Accessory Cable 19B802554P24.
9. Connect the Y-cable’s 8-pin connector to the 8-pi
n connector of Accessory Cable 19B802554P24.
Refer to Figure 11-2 as necessary.
10. Connect the PTT switch to the Y-cable by mating the plug
on the end of the switch’s cable to the jack
of the Y-cable.
11. Route the long end of the Y-cable (with the 4-conductor quick-disconnect jack) to a location near hip-
position of the motorcycle operator, or to another convenient location per request of the motorcycle
operator/customer.
12. As illustrated in Figure 11-2, connect the Belt Box to the Y-cable’s 4-conductor quick-disconnect
jack.
11.3 HEADSET OPERATION
If the motorcycle is equipped with Headset Helmet Kit Interface Cable option SM-MCH-71GT or SM-
MCK-71GT, to transmit, simply press and hold the PTT button on the PTT switch then talk into the
headset’s mic. To receive, stop talking and release the PTT button. When receiving, adjust the volume
control on the control unit for the desired speaker audio level.
If the motorcycle is equipped with Headset Helmet Kit Interface Cable option SM-MCH-72GT, SM-
MCH-73GT or SM-MCK-72GT, to transmit, press and hold the three-position toggle switch to its
momentary (PTT) position and then talk into the headset’s mic. To receive, stop talking and release the
toggle switch so it returns to its center position. In the center position, the radio is in monitor mode
(programmed receive decoder is deactivated). To exit the monitor mode and re-activate the programmed
receive decoder, press the toggle switch to the latched position. When receiving, adjust the volume
control on the control unit for the desired speaker audio level.
To Next Page
Loading...
