MM-015371-001, Rev. C
67
13.6 CH-721 SERIAL PROGRAMMING CABLE CA-104861
Serial Programming Cable CA-104861 (5 feet) can be used to program and configure the CH-721 control
head via a Personal Computer (PC). This cable has a female DB-9 connector on one end for connection to
the PC’s serial port and a male DB-9 connector on the other end for connection to the serial port on the
rear of the head. The cable’s assembly and wiring diagrams are shown in Figure 13-6 below.
(Made From PS-CA-104861 Rev. A)
Figure 13-6: Programming Cable CA-104861
To Next Page
Loading...
