Harvia XENIO CX180 - Resetting the Overheat Protector; Spare Parts; 过热保护器复位

EN
中
14
WX232
Figure 10. Reset button of the overheat protector
图 10. 过热保护器复位
4. SPARE PARTS 4.
零件
1 Control panel (CX180)
控制面板 (CX180)
WX385
2 Temperature sensor
感温器
WX232
3
Data cable 5 m
数据线 5 米
WX311
4 Data cable extension 10 m (optional)
附加数据线 10 米(可选配)
WX313
5
Circuit board
控制器主电路板
WX386
3.4. Resetting the Overheat Protector
The sensor box (WX232) contains a temperature
sensor and an overheat protector. If the
temperature in the sensor’s environment rises too
high, the overheat protector cuts off the heater
power. Resetting the overheat protector is shown
in figure 10.
Note! The reason for the going off must be deter-
mined before the button is pressed.
3.4. 过热保护器复位
感温器(WX232)内包含温度传感器及可复位式过热
保护器。当传感器周边温度过热时过热保护器会
切断桑拿炉电源。见图10.
注意！按下复位按钮之前必须确定故障原因巳修
理好。
3 4
1 2
5