EN
中
4
Description/错误信息代码说明 Remedy/排除问题方法
E1
Temperature sensor's measuring
circuit broken.
Check the red and yellow wires to the temperature sensor and their
connections (see figure 6) for faulties.
感温器电路断线 检查感温器至控制装置之间红,黃色电线连接(见图.6)
E2
Temperature sensor's measuring
circuit short-circuited.
Check the red and yellow wires to the temperature sensor and their
connections (see figure 6) for faulties.
感温器电路短路 检查感温器至控制装置之间红,黃色电线连接(见图.6)
E3
Overheat protector's measuring
circuit broken.
Press the overheat protector's reset button ( 3.4.).
Check the blue and white wires to the temperature sensor and their
connections (see figure 6) for faulties.
过热保护器电路断线 按过热保护器上复位按钮( 见章节3.4.)
检查感温器至控制装置之间蓝,白色电线
E9
Connection failure in the system. Switch the power off from the main switch (figure 1). Check the data
cable, sensor cable/s and their connections. Switch the power on.
装置连接故障 从主开关关闭电源(见图1.)，检查数据线、感温器线路及各自之连接。重新
开启电源
1.3. Troubleshooting
If an error occurs, the heater power will cut off and
the control panel will show an error message ”E
(number)”, which helps troubleshooting the cause
for the error. Table 1.
Note! All service operations must be done by pro-
fessional maintenance personnel. No user-service-
able parts inside.
1.3. 问题解决
如有问题发生，控制器将会切断桑拿炉电源，控制面
板显示错误信息代码， "E(数字)"有助找出问题之原
因。见表1
注意! 所有维修业务必须由专业维修人员處理。控制
器内没有用户可维修的部件。
Table 1. Error messages. Note! All service operations must be done by professional maintenance personnel.
表1. 错误信息代码. 注意! 所有维修业务必须由专业维修人员處理
To Next Page
Loading...
Need help?
General
