Hasselblad H1D User Manual

154
155
Hasselblad H1D
Example of viewnder LCD display showing
Flash set to Rear sync as well as - 1EV exposure
compensation.
Hasselblad H1D
To change the balance between ash output and camera exposure requirements to produce a
variety of eects, use the exposure compensation function. For various long exposure eects
use the sync function. To make ash exposure tests use the ash measure function.
To access the controls:
1) Activate the camera and press the FLASH button once.
2) Turn the front control wheel to set the amount of compensation required:
• from +3EV through -3EV (amount dependent on ISO value
)
3) Turn the rear control wheel to set:
• normal sync (ash triggered just after the shutter opens)
• rear sync (ash triggered just before the shutter closes)
• ash measure (with non-TTL ash units or TTL units in Manual mode)
4) The grip LCD shows the ash mode - Normal or Rear - in the standard display. However,
when set to Flash Measure, a specic screen requests you to press the AE-L button in
order to make a reading.
Integral ash
The integral ash unit features the following specications:
Guide no. 12
Coverage 56º horizontal, 44º vertical
Maximum light fall-o at side centres - 1EV (50%)
Colour temperature (full ash) 5,000 – 5,600º K
4

Hasselblad H1D Specifications

General

Brand	Hasselblad
Model	H1D
Category	Digital Camera
Language	English