! Do not attempt to clean the screen by immersing it in water, or use any kind of cleaning
uid. If the screen becomes damp, do not use hot air to dry it. Use a soft cloth on the upper
surface only. Seek advice from an Authorized Hasselblad Service Center if the screen becomes
particularly soiled. Remember that particles or greasy marks on the screen might impair the
viewnder image but have no eect whatsoever on the recorded image.
Accessory connection
On the le hand side of the camera body are two accessory retaining screw threads (M5), as
well as a databus connector, protected beneath a cover. Various accessories, an IR-remote
control for example, can be attached. e cover is removed by sliding it to the le.
PC-connector
A PC connector for non TTL-ash synchronisation is located on the le side of the body. It
is protected by a captive rubber
To Next Page
Loading...
