If you attempt to make an exposure with the darkslide is closed, however, you will receive a
warning message in the viewnder and grip LCDs – ‘e darkslide is closed’.
Darkslide key H
Withdraws and replaces the darkslide. Fold out the key and turn it counter-clockwise 360°
(towards the open symbol) to withdraw it and clockwise 360° (towards the closed
symbol) to replace it.
! The darkslide can only be withdrawn when the magazine is attached to the camera.
Film tab holder I
Holds an ID tab from the lm roll pack as a reminder of the type of lm loaded. Don’t forget
to change it if you change lm type!
Film holder key J
Secures the lm holder in the magazine. Fold out the key and turn counter-clockwise 90° to
remove the lm holder and turn clockwise 90˚ to lock the lm holder in place.
Magazine settings lock K
All settings can be locked to avoid inadvertent changes. To change the settings, slide the
settings lock (see diag) to the right until it stops. Aer the changes have been made, slide the
settings lock to the le (see symbol on magazine) again to secure the new settings.
Databus interface
Data interface between magazine and camera. Ensure the contacts are kept clean and pro-
To Next Page
Loading...
Need help?
General
