5. Check the Renumber from checkbox if you want the shots to be renumbered while loaded
- type the starting number in the number eld.
6. Click Load...
The images will be transferred to and saved as ‘3F’ les in the currently selected Thumbnails
folder on the computer.
Tethered use (connected to a computer)
e basic hardware requirements for the PC or Macintosh system used in connection with
an H1D are as follows:
• Screen resolution of 800 x 600 pixels with true colors (24-bits).
• Mouse or other pointing device.
• FireWire interface.
For information about the processor, operating system, RAM and hard disk requirements
please refer to the ‘FlexColor Soware Reference’ manual, that comes with the FlexColor
soware.
e H1D is very easy to connect to a computer. Use the procedures below to set up your
system.
To Next Page
Loading...
