Hold the SETUP button again within 3 seconds.
Pressing is signaled by continuous lighting of the
diode.
The LED will flash rapidly.
Release the SETUP button.
After releasing the button, the LED will show the
current status of the function. The lighted on
means the function is active, and the light off
means the function is inactive.
To change the state of the function to the opposite,
press the SETUP button briefly within 3 seconds.
After 3s from the last press, the LED will flash 3
times. The controller will remember the settings
and return to normal operation.
AUTOCLOSE FUNCTION
When the gate stops, after the OPEN signal, the time set by the user is counted down, after which the
CLOSING will take place. The light shines during the countdown. For the user's safety, photocells are
required (so that the gate does not close when there is an obstacle in its light!). Additionally, when the
PHOTO CLOSE function is on, the photocells will shorten the auto-closing time and after detecting the
passage, the gate will close after 5 seconds. If less than 5s are left until automatic closing, each
detected passage will cause the countdown of an additional 5s. If the gate is in the fully open position,
each signal trying to activate it in the opening direction will start the countdown of the auto-closing
time.
ATTENTION! Stopping the gate with a transmitter or control button during closing stops the
countdown. Therefore, to close the gate, press the control button again - you can use it when you
need to leave the gate open for some time.
To turn on the function, set the AUTO CL switch to
the ON position.
Set the desired auto-closing time according to the
procedure.
SETTING THE AUTO-CLOSING TIME
To disable the function, set the AUTO CL switch to
the OFF position.
SETTING THE AUTO-CLOSING TIME
We set it in the range from 15s to 25min with a step of 15s. By default: 6min
The AUTO CL switch must be in the ON position.
Hold down the SETUP button for less than 3s.
When the button is pressed, the LED lights up.
Release the SETUP button.
The LED will flash rapidly.
To Next Page
Loading...
