HATO 400Y - Switching Off the Wicket Function

If the gate is in the fully closed position, the LED
will flash quickly and items marked with asterisks *
should be omitted.
CL
* If the gate is not fully closed, the LED will flash
slowly.
?
* Press the SBS sequence control button for less
than 3s or the transmitter button assigned to the
SBS function.
lub SBS
* Brama zacznie się zamykać. Dioda LED będzie
świecić.
* The gate will start to close. The LED will be on.
CL
Press the SBS sequence control button for less
than 3s or the transmitter button assigned to the
SBS function.
or SBS
The gate will begin to open. The LED will be on.
To designate the stop positions, press the SBS
sequence control button for less than 3s or the
transmitter button assigned to the SBS function.
or SBS
The gate will stop. The LED will turn off.
Press the SBS sequence control button for less
than 3s or the transmitter button assigned to the
SBS function.
or SBS
The LED will blink 3 times to confirm that the
settings have been saved. The controller will return
to normal operation.
ATTENTION!
To return to the normal operation without saving
the settings, press the SETUP button for less than 3
seconds. The gate will stop and the LED will blink
once.
ATTENTION!
After each adjustment of the motor power on
the VR1 potentiometer, the procedure of
programming the door opening width should
be repeated.
SWITCHING OFF THE WICKET FUNCTION
Hold down the SETUP button.
The LED will turn on, then turn off and on again.