37
5.5. Action to be taken during using
5.5.1 Permitted driving inclinations for a tractor on a slope
(continuous driving to ensure a sufficient lubrication)
Permitted inclinations:
Approach angle : 40 degrees
Departure angle : 25 degrees
Ramp angle : 40 degrees
WARNING: Angles for safe driving should
be smaller to avoid the tractor tipping over.
E 5.5.2
.
Use of snow chains
Snow chains must always be fitted on the front
wheels if they are fitted on the rear wheels. Check
that the chains are suitably tensioned so that the
mudguards are not damaged. When needed
adjust the turning angle of the tyres/tires.
5.5.3
Front mudguards
After transportation the front mudguards have to
be checked/adjusted for max turning angle, and
moved to the right width so that the mudguards do
not touch the tractor chassis.
The min. distance of the mudguard frame fromthe
tyres:
--- sideways 40 mm
--- vertically 60 mm
5.5.4.
Towing the tractor
If possible towing should be avoided when
the
engine is not running, because the
pressure
lubrication of the gearbox does not operate. If
towing can not be avoided, the range lever must
be in neutral (the rightmost lever) and the gear
lever engaged in gear. The forward/reverse
gear lever must also be engaged. The gearbox
must have normal filling of oil.
NOTE: Towing speed should not exceed 15 km/h.
5.5.5.
Fold down Rops
The tractors, which have the fold down Rops, the
Rops must always be kept locked to the upper
position, when it is possible.
If a fold down ROPS is installed DO NOT wear
seat belt when the ROPS is in the folded down
position.
For falling down the arch loosen the pin and turn
the arch backwards, fasten the pins back into the
holes.
5.5.6.
Ballast weights
IMPORTANT: When using salt liquid as balast
weight in the wheels, the factory does not take the
responsibility for the damages caused by salt.