HATTAT A110 - Specifications

72
9.6.2. Adjusting track width: Rear axle
Tractor models Rear tire The front tire track width
A70 / A70L / 80 / A80LTurbo 4x2
460/85R34 1508 - 1708
A70 / A70L / 80/A80L Turbo 4x4
460/85R34 1508 - 1708
A90 / 100 / 110 Turbo 4x2
460/85R34 1508 - 1708
A90 / 100 / 110 Turbo 4x4
460/85R34 1508 - 1708
Adjusting front and rear wheel track widths is done in the same way.
Before adjusting scotch the front wheels to prevent the tractor from moving. Raise the rear wheels off the
ground and position sturdy axle stands under the axle housing.
The standard track widths are underlined.
9.7. If the tractor is not used
9.7.1. Storing the tractor
For a period shorter than two months
No special measures are required provided that:
- The tractor has been regularly maintained
- The tractor is clean and has been washed
- The coolant contains enough anti-corrosion liquid
- The fuel tank is full
- The battery is kept in a suitable place
- The air conditioning is operated for a few minutes
at least once a month.
For a period longer than two months
- Clean, wash and lubricate the tractor
- Clean the fuel tank
- Fill the fuel tank with fuel
- Change pre-filter of the fuel system, distributor
models
- Change the fuel filter and bleed the fuel system of
air.
- Clean the air cleaner
- Change engine oil and oil filter
- Make sure that the coolant contains enough anti-
corrosion liquid and check the charge in the battery
- Run the engine until it is thoroughly warm
- Lower the hydraulic lift to its lower position
- Stop the engine, unscrew the injectors and pour
0.1 liter of preserving oil into each cylinder.
- Crank the engine a few revs. Refit the injectors
with new gaskets.
- Remove the battery, clean it and store it in a cool
dry place where there is an even temperature.
Charge the battery every 2 months.
- Slacken the fan belt (compression belt)
- Protect exposed parts against corrosion by
applying anti-corrosion oil.
- Cover the air induction pipe to the air cleaner and
the exhaust pipe with a plastic bag or similar.
- Operate the air conditioning for a few minutes at
least once a month.
9.7.2. Removing the tractor from
storage
After a period shorter than two months
- Fit the battery (fully charged)
- Check the oil level in the engine and transmission,
the coolant level in the radiator, the electrolyte level
in the battery and the tyre pressures.
- Carry out the general lubrication
- Bleed the fuel system if required
- Start the engine without racing it
- Test-run the tractor and make sure that everything
works correctly.
After a period longer than two months
- Check the tyre/tire pressures
- Remove the protective covers
- Turn the radiator fan carefully forwards and
backward, so that the sealing ring of the coolant
pump works loose (it may have stuck to the shaft).
- Wash off any anti-corrosion oil applied to the
exterior of the tractor
- Tension the fan belt (compression belt)
- Remove the valve cover and lubricate the rocker
mechanism with engine lubricating oil.
- Check the oil level in the engine and transmission,
the coolant level in the radiator and the electrolyte
level in the battery
- Bleed the fuel system of air
- Refit the battery (fully charged)
- Start the engine without racing it
- Test-run the tractor.