1.161.16
OPERATING THE MOWER
WARNING - PREVENT ACCIDENTS: Before mow-
ing, thoroughly inspect the area where the mower is to
be used and remove all objects which when contacted
by the mower cutterbar could become dangerous pro-
jectiles.
Inspect the area for hidden obstructions which when
contacted by the cutterbar could risk health and safety.
Remember the location of these obstructions and ensure
that you mow around them.
IMPORTANT - PREVENT ENGINE DAMAGE : DO
NOT use the mower on a slope greater than 20 degrees.
To adjust the height of cut: Grip the lever and pull side-
ways to disengage it from the locking notch, then push for-
wards to lower or pull backwards to raise the height of cut.
Finally release the lever at the required position and ensure
it locks firmly into one of the nine notch settings.
Always select a height of cut to suit operating conditions.
Aim to prevent engine overloading and blockages by
avoiding low cuts in long grass conditions. Be prepared to
make two cuts when the grass is long.
SAFETY NOTICE
HEIGHT OF CUT
max.
To Next Page
Loading...
Need help?
General
