1.271.27
MAINTENANCE
CUTTERBAR Continued.
How to sharpen and balance the cutterbar: A slightly
worn cutterbar may be re-sharpened. Both cutting edges
must be sharpened equally to ensure balance. Sharpen the
cutterbar every 25 mowing hours or more frequently if con-
ditions require. Remove the cutterbar from the mower and
clean using a brush and water. Inspect the cutterbar for
signs of damage.
WARNING - PREVENT ACCIDENTS : DO NOT use a
damaged or excessively worn cutterbar.
Sharpen both cutting edges with a flat file to restore the
original cutting edge.
Ensure that the cutterbar is balanced. Use a screw driver
with a round shaft to support the cutterbar through its centre
hole. Hold the cutterbar horizontal and then release. A bal-
anced cutterbar will remain horizontal. If the cutterbar is
not balanced the heavy end will rotate downwards. Sharpen
the heavy end until the cutterbar is correctly balanced.
To Next Page
Loading...
Need help?
General
