8
Pool Solar
88°F
+
>
>
Adjust the desired pool temperature (Off, 65°F, 66°F, ...103°F, 104°F, Off)
Move to previous/next menu item
The pool solar setting will only appear if the system has been setup for “pool only” or “pool
and spa” operation and the solar control is enabled. The solar system will turn on whenever
the pool/spa valves are in the “pool only” or “spa spillover” position and the filter pump is
running and the pool water temperature is less than the desired temperature setting and solar
heat is available.
Super Chlorinate
On
+
>
>
Turn super chlorinate on or off
Move to previous/next menu item
This setting will only appear if “chlorinator” is enabled. When you have an unusually high
bather load, a large amount of rain, a cloudy water condition, or any other condition that
requires a large amount of chlorine to be introduced to the pool, activate the Aqua Logic
Super-Chlorinate function. The Aqua Logic will turn on the filter pump, set the pool/spa
valves to the correct position, and set the chlorine generator to maximum output. The
superchlorinate function will continue for the programmed number of hours (see Timers/
Super Chlorinate Hours below) overriding the normal filter pump timeclock settings. At the
end of the super chlorinate period, the pool will return to normal operation.
If you manually turn off the filter pump (using the “Filter” button on any display/keypad),
the super chlorinate function terminates. When you turn the filter pump back on, super
chlorinate will resume for the balance of the programmed number of hours.
Spa Chlorinator
3%
+
>
>
Adjust the desired chlorinator output for spa (0,1,2,3...9,10,15,20...95,100%)
Move to previous/next menu item
This setting will appear only if the system has been setup for “chlorinator” and “spa only”
or “pool and spa”. It will determine the chlorinator output when the system is operating in
spa-only mode. The actual amount of chlorine introduced into the spa is determined by: this
setting, the amount of time the pool operates in spa-only mode, the water temperature, and
the amount of salt in the water. If the filter pump is running due to the freeze protection
feature, then the chlorinator will not operate during this time.
Pool Chlorinator
60%
+
>
>
Adjust the desired chlorinator output for pool (0,1,2,3...9,10,15,20...95,100%)
Move to previous/next menu item
This setting will appear only if the system has been setup for “pool only” or “pool and spa”.
It will determine the chlorinator output when the system is operating in pool-only or spa
spillover modes. The actual amount of chlorine introduced into the pool is determined by:
this setting, the amount of time the filter pump is running, the water temperature, and the
amount of salt in the water. If the filter pump is running due to the freeze protection feature,
then the chlorinator will not operate during this time.
To Next Page
Loading...
Need help?
General
