USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
33
Wireless Waterproof - This option displays the HUA of each connected waterproof
remote control and allows you to enable or disable the units.
SC upload files - This option can be used to upload files to Hayward Technical Ser-
vice for evaluation and troubleshooting.
Web Server - This is for internal use only.
Boot Image - A copy of the unit’s operating system is kept on internal storage in case
of file corruption. If necessary, Hayward Technical Service may instruct you to use this
option.
Diag Info - This option accesses the OmniHub’s diagnostic information. Hayward
Technical Service might require this information to help troubleshoot or diagnose is-
sues.
Toggle Demo Mode - Demo mode is used for display purposes only. When in Demo
Mode, the OmniHub runs a simulation allowing users to view and interact with preset
screens. The OmniHub is not functional when running in Demo Mode.
Datalog - Used with the guidance of Hayward Technical Service to troubleshoot or
diagnose issues.
Upgrade - Use this button to upgrade firmware to the latest release. Refer to the
information at the bottom of the page.
Daylight - This function will invert the colors on the display to make it easier to see
in some lighting conditions.
Sysinfo - View current firmware versions for OmniHub components.
Factory Reset - Deletes all existing configuration and settings.
Calibrate - This function allows for the recalibration of the Local Terminal.
Light Mode - Change the operation mode of Universal ColorLogic lights.
Firmware Upgrade
The OmniHub’s firmware is the basic operating system that runs the unit. The OmniHub was shipped
with the version of firmware that was available at the time of release. There may be a newer version
available and if so, we encourage you to upgrade. Also, if you have experienced problems, Hayward
Technical Support may advise you to upgrade your OmniHub firmware. To upgrade your firmware
follow the instructions on the next page:
To Next Page
Loading...
