Hayward OmniHub - USB Firmware Upgrade Steps; Selecting File and Initiating USB Upgrade

USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
36
9. Select “MSP” and touch the Save button.
10. The OmniHub will now look at your USB thumb drive. Select the firmware file that was saved
from the website and then touch the Save button.
11. Touch Save to begin the upgrade. After the upgrade is finished, touch Save to restart.
12. After the OmniHub has restarted, exit Service Mode and resume operation.
select device
component HUA current version
MSP 0-0-0-0 R4.0.0
MP 1-65-0-2a-a6 R3.2.0
COMPONENT
selection
select device
component HUA current version
MSP 0-0-0-0 R4.0.0
MP 1-65-0-2a-a6 R3.2.0
COMPONENT
selection
select le
USB/
MSP_AR_R0403000
FILE
selection
...\
select le
USB/
MSP_AR_R0403000
FILE
selection
...\
ready to upgrade
component firmware file
MSP MSP_AR_R0403000
UPGRADE
rmware
0%
success ready to restart
component firmware file
MSP MSP_AR_R0403000
UPGRADE
rmware
100%