Operating Instructions
Radio Transmitter eco
Page 18 / 24 AOEM1G30 [PMTS/DOKUS]
HBC-radiomatic GmbH • 74564 Crailsheim • Germany
2007-06-18 Information and specifications subject to change without notice.
Radio Control System
3 Fault Correction
Note:
Please check the functions using the cabin or cable controls first!
Problem Possible Cause Remedy
Transmitter does not react
when switched on.
− No power.
− Check the battery
contacts for damage or
contamination.
− Insert a fully charged
battery into the battery
compartment.
− Recharge battery.
Low-power indicator after
minimal operating time, i.e.
the display in the
transmitter flashes red.
− Battery contacts are
contaminated or
damaged.
− Battery not charged.
− Battery defective.
− Check battery contacts
for damage or
contamination.
− Fully recharge battery.
− Ensure that recharging
process runs correctly.
− Check transmitter
functions using a fully
charged or replacement
battery.
The display in the
transmitter flashes green
but it is not possible to
effect control commands.
− The receiver has no
service voltage.
− There is no radio
communication available.
− The "Crane On"
command has not been
given.
− Check the connecting
cable to the receiver.
− Check the functions via
the LEDs in the radio
status panel of the
receiver.
Some commands are not
carried out.
− The receiver is defective.
− There is an interruption
in the connecting cable
to the crane or machine.
− Check if all connecting
cables and cable
junctions are tight.
− Contact a service
technician if necessary.
To Next Page
Loading...
