Operating Instructions
Radio Transmitter eco
Page 6 / 24 AOEM1G30 [PMTS/DOKUS]
HBC-radiomatic GmbH • 74564 Crailsheim • Germany
2007-06-18 Information and specifications subject to change without notice.
Radio Control System
1.3 Operator Safety Instructions
Ø Before beginning crane operation, position yourself so that you have a clear and
complete overview of the working radius of the crane or machine.
Ø Please be careful of assumed changes of direction when you change position!
Ø In case of an emergency or any disturbances within the working range of the crane
or machine, switch the transmitter off immediately by pressing the STOP switch.
Should the transmitter show signs of technical failure or breakdown, disconnect the
radio control system immediately!
Ø Always switch off the transmitter during breaks and after finishing work to avoid
operating errors or any accidental actuation of operator controls.
– These precautions are particularly important whenever changing your position or
climbing over an obstacle.
Ø Never leave an activated transmitter unattended. The operator undertakes to follow
and comply with the authoritative regulations for worker safety and accident
prevention.
Note:
In the event of an interruption of the radio link during a working cycle – what can
occasionally happen – both transmitter and receiver automatically shut down (so-called
"compulsory switch-off").
To reactivate the system release all operator controls, such as pushbuttons or
momentary contacts, and allow the control elements to return to their zero position. The
system must be reactivated before the crane or machine can react to control commands!
This feature hinders any uncontrolled or unwanted crane or machine movement, should
the radio link be interrupted.
Please observe:
If the crane is equipped with a Main Contactor you must press the button before the
crane can react again to control commands!
To Next Page
Loading...
