Operating Instructions
Radio Transmitter eco
Page 8 / 24 AOEM1G30 [PMTS/DOKUS]
HBC-radiomatic GmbH • 74564 Crailsheim • Germany
2007-06-18 Information and specifications subject to change without notice.
Radio Control System
Automatic Switch-OFF (APO Function)
For safety reasons we have equipped the transmitter with an automatic switch-OFF
(APO = Automatic Power Off function). The transmitter is automatically put out of circuit
after 15 minutes of non-use.
The automatic switch-OFF also saves battery power.
The transmitter can be reactivated by means of the button.
Note:
The automatic switch-OFF (APO function) does not relieve the operator of his
responsibility to turn off the transmitter when not in use!
Frequency Selection
Fixed frequency
If the identification plate in the battery compartment of the transmitter shows a frequency
value (e.g. 433.500 MHz), the transmitter operates with a fixed frequency.
Please contact your service department if the frequency has to be changed because the
frequency channel is already assigned to another operator.
Manual frequency switching
If the identification plate in the battery compartment of the transmitter shows the label
man, the transmitter features manual frequency switching.
This function can be used to change the frequency channel during radio operation. Press
the button into the first step until an acoustic signal sounds. Then release the button.
radiomatic
®
AFS option
If the identification plate in the battery compartment of the transmitter shows the label
AFS, the transmitter is equipped with radiomatic
®
AFS (Automatic Frequency
Selection).
When activating the transmitter radiomatic
®
AFS (Automatic Frequency Selection) will
check if the present frequency channel is free. If the frequency channel is occupied, the
system automatically finds and saves a free frequency channel.
The radiomatic
®
AFS option also includes the manual frequency switching function for
changing the frequency channel during radio operation.
To Next Page
Loading...
