HBC eco - Maintenance; 4.1 In the Event of a Fault

Operating Instructions
Radio Transmitter eco
AOEM1G30 [PMTS/DOKUS] Page 19 / 24
HBC-radiomatic GmbH • 74564 Crailsheim • Germany
Information and specifications subject to change without notice. 2007-06-18
Radio Control System
4 Maintenance
The radio control system is virtually maintenance-free. The following points, however,
should be taken into consideration:
Ø Ensure that the STOP switch works smoothly.
Contaminants of any kind can reduce or fully block the switch function.
Ø Inspect the rubber bellows of the operating elements regularly for leak-tightness.
Replace immediately if cracks appear since the penetration of dirt and humidity may
damage the function of the operating elements.
Ø Charge and discharge transmitter batteries regularly.
Ø Never use a high-pressure cleaner or steam jet cleaner to "clean" the transmitter.
Use a soft brush or cloth only!
Note:
Should you have any problems with the radio control system, contact your local
distributor or HBC-radiomatic GmbH.
4.1 In the Event of a Fault
Warning:
Never operate a crane or machine with a faulty or defective radio control system!
Ø Never try to repair the transmitter electronics! Opening the transmitter housing
terminates the manufacturer guarantee.
– Send any defective or faulty equipment to your local distributor or to the
manufacturer. They are experts and have the necessary know-how and OEM
spare parts.
– Always send both transmitter and receiver and enclose a detailed description of
the problem.
– Do not forget to enclose your address and telephone number so that we can get
in touch with you quickly if necessary.
Ø To avoid damage during transport, use the original packing supplied with the
transmitter and receiver, otherwise pack securely. Send the consignment to your
distributor or to the following address:
HBC-radiomatic GmbH
Haller Strasse 47 – 53
74564 Crailsheim, Germany
Ø Should you choose to deliver a defective radio control system personally to your
distributor or our factory, please call and arrange an appointment.
HBC-radiomatic GmbH
– Customer Services / Repair Service –
Tel.: +49 ( 0 ) 79 51 – 3 93 – 800