-------------------------------------------------------------------------------------GEN III OPERATIONS MANUAL
HealthCare Information, LLC
12
NOTE: Zenith, and Philips type pillow speakers refers to the digital code the pillow speakers send to the TV,
not the manufacturer of the pillow speaker. Visitor Station refers to the optional Visitors Station that
allows visitors to control the set without interrupting the patient. The Single Pillow Speaker Board
Ver.1 will also support RCA pillow speakers.
The ¼” jack and the 6-pin jack cannot be set for different types of pillow speakers with the Single Pillow Speaker
Board.
Dual Pillow Speaker Board
The Dual Pillow Speaker Board allows two different pillow speakers or one pillow speaker and a Visitor Station to be
connected to the set at the same time. You will need to set the ¼” jack and the 6-pin jack separately. You will need one
jumper with a 6-Pin Amphenol plug on one end and a second jumper with a ¼ inch jack on one end. The opposite ends
of both cables should match your wall jacks. Three button analog pillow speakers and 2 function sip & puff devices
must use the 6-Pin Amphenol jack only.
Third Party Controllers
Connect third party controllers to the RJ-12 communications port(s). Sets with single pillow speaker boards will have
one RJ-12 jack and sets with dual pillow speaker boards (optional) will have two RJ-12 ports. If you have a dual pillow
speaker board please contact your dealer to determine which jack to use for you application.
Software Updates
Software can be updated via the USB ports. TV software (M-star) is updated via the USB SW-update port on the rear
jack panel located next to the digital audio jack. This is the only USB port that can be use for TV software updates.
Android system updates are installed via the USB port next to the RJ-45 jack (Ethernet port) or the USB port located on
the left side of the TV.
Contact you dealer for availability of updates.
To Next Page
Loading...
