-------------------------------------------------------------------------------------GEN III OPERATIONS MANUAL
HealthCare Information, LLC
27
1. Select or click on the Settings app. Enter password.
2. Select or click on Launcher Setting the Application manager.
3. Use the up/down arrow buttons to highlight the app.
4. Press the “ENTER” button or click on the app to toggle the location. A checked
box on the right indicates which folder the app will be in. In no box is checked
the app will be in the App folder.
Ethernet The RJ-45 Ethernet port must be setup is you wish to use a wired network connection for Internet
access and other network functions. To set up the RJ-45 Ethernet port:
1. Select or click on the Settings app. And enter the password.
2. Select “Ethernet”. Press the “ENTER” button or click anywhere on the Ethernet line to
toggle the RJ-45 Ethernet port on or off. Must be on for the Ethernet port to function. A
check mark in the box on the right side of the line indicates on.
3. Select “Ethernet configuration”.
4. Select “Connection Type”. Contact your network administrator to determine Connection
type and if necessary IP, Netmask, DNS and Gateway addresses.
A. DHCP Select this if your IP address will be determined by your network DHCP
server. If DHCP is selected no other information is needed. Select or
click on the “Save” button.
b. Static IP Select this if you need a fixed IP address that will not change. A static
IP address is required for use with a MediaCare system. You must enter
the IP Address, Netmask, DNS address and Gateway addresses provided
by your system administrator. Once all information has been entered
Select or click on the “Save” button.
Wireless The Android™ sets can connect to a local network via wireless WiFi. The optional WiFi adaptor
must be installed. To setup wireless connectivity:
1. Select or click on the Settings app.
2. Enter password.
3. Select or click on Wireless and networks.
4. Press the “ENTER” button or click on the first line to turn the WiFi adaptor on and off. A
check in the box on the right side of the line indicates WiFi adaptor is on. Must be ON for
wireless connectivity.
5. Select Wi-Fi settings.
6. Turn the WiFi adaptor on and off by clicking on the first line or selecting with the up/down
arrow buttons and pressing the “ENTER” button. A check in the box on the right side of the
line indicates the WiFi is on. Must be on for wireless connectivity.
7. You will see a list of available WiFi networks. Select or click on the network you wish to
connect to. A window will open showing security type and signal strength. Select or click
the “Connect” button. If the network you selected is a password protected network you will
be asked for the password first. Contact your network administrator for the password. If
you wish to see the password as you enter it select or click the show password box. When
finished select or click the “Connect” button.
To Next Page
