-------------------------------------------------------------------------------------GEN III OPERATIONS MANUAL
HealthCare Information, LLC
20
FG Opacity Sets transparency of text. Selections are:
Default – Solid – Flashing –
Translucent - Transparent
BG Opacity Sets background transparency. Selections are:
Default – Solid – Flashing –
Translucent – Transparent
NOTE: Be careful when using custom font settings. For example if you set the FG Color and BG
Color to the same color you will not be able to see the text.
Restore Default Resets the set to factory defaults. All setting and channel line up will be lost. You will be prompted
before this action is carried out. You can also reset the set by entering function code 15719
(FUNCTION – 0 – 15719) with an IR remote.
Input Label Allows the names of the input sources to be changed. To change the name of an input source.
1. Use the up/down arrow buttons to select the input name you wish to change.
2. Press the right arrow button.
3. Press the right/left arrow buttons to select from a list of standard names or press the down
arrow button to enter a custom name.
4. To enter a custom name use the right/left arrow buttons to select the character to enter or
change then use the up/down arrow button to change. Press the “ENTER” button when
done.
Bank Sel. Selects which channel bank (tier) to use. There are 4 banks available.
IR Band Selects which IR band to use. The HCI IR remote must match the IR band setting. To change the IR
remote band press and hold the power button on the IR remote for 10 seconds.
HCI Setup Special hospital settings.
SIP & PUFF When on allow use of a sip & puff device to control the set. This is for handicapped
operation.
Serial Control Sets the type of serial control via the RJ-12 jack(s) on the rear jack panel. The Dual Pillow
Speaker board option will have 2 RJ-12 jacks. Selections are:
Serial Control OFF – DVD Control – LodgeNetControl – HCIControl
Serial Control Off No commands are accepted through the serial port(s).
DVD Control Used to control HCI DVD player.
LodgeNetControl Used for LodgeNet systems.
HCIControl Serial control using standard HCI codes.
To Next Page
Loading...
