-------------------------------------------------------------------------------------GEN III OPERATIONS MANUAL
HealthCare Information, LLC
22
US Settings for United States Parental Control. (V-Chip)
TV Parental control settings for TV shows.
MPAA Parental control settings for movies.
Canada Settings for Canadian Parental Control. (V-Chip)
Canada Eng English parental control setting for Canada
Canada Fre French parental control settings for Canada
Channel Channel line up settings and auto scan. Press the “SETUP” button to go back one menu.
TV Source Set to Cable if TV signal source is from a cable system. This applies to most in house systems as
well. Set to Air if TV signal is from an off air antenna.
NOTE: Most in house systems that receive local channel from an off air antenna convert the off air
signals to Cable signal. In these cases TV should be set to Cable. Check with your TV
system administrator to determine which setting to use.
Auto Scan Automatically scans all channels for active channel and add to the channel list. Select the scan
methods and press to right arrow button to start Auto Scan. Scanning for digital channels will take several minutes.
Scan all channels Scans all channels (1-135) for both analog and viewable digital channels. Adds all
channels found to the channel lineup.
Digital channel only Scans all channels (1-135) for viewable digital channels. Adds all channels found
to the channel lineup. Analog channels will not be added to the lineup.
Analog channel only Scans all channels (1-135) for analog channels. Adds all channels found to the
channel lineup. Digital channels will not be added to the lineup.
NOTE: All over the air broadcasts in the US are digital.
When scanning for all channels the TV will first scan all channels for digital
channels and then scan all channels for analog channels. Digital scanning will take
several minutes.
To exit without starting a scan press the “ESC” key. You can also exit a scan once
it has started using the “ESC” key however, all channels will be erased.
Bank Bank editing. This screen allows you to adjust the channel line up in each bank after an Auto Scan
has been run. Use the up/down arrow buttons to select the channel to add or delete. Use the right/left
arrow buttons to select the bank to add to or delete from. Press the “ENTER” button to add or delete
the channel. An “X” indicated the channel has been added. A “*” indicates the channel has been
deleted.
Show/Hide & Use this menu to enable/disable channels and to add channels to the EDU (Education
EDU Channel) list. EDU is also called FAV (Favorites) on some models.
1. Press the Right arrow button to enter the Show/Hide & EDU.
2. Use the Up/Down arrow buttons to select the channel to change.
3. Use the left right arrow buttons to select ON/OFF or EDU
4. Press the “ENTER” button to change.
To Next Page
Loading...
