pickups, we recommend using cables 2m ( 6' ) max. if
standard quality ( e.g. Klotz or Van Damme ), and 3m (9')
max. with note: remove special low capacitance cable,
(e.g. Sommer Cable into Pre-amp Input)
Headway offers Sommer Cable Jack Leads and quality
Standard braided cable Jack leads with quality
lightweight Jack plugs
For High Impedance Passive Piezo Pickups, such as
Piezo Ceramic or Headway's popular "The Band", use
quality cables of 3-5m (9'-15') max. to EDB-H.E are
recommended
For Lower Impedence Magnetic Passive Pickups and
Dynamic Mic's, a max. of 6m is recommended
3.1.2 LEADS FOR ACTIVE PICKUPS: quality Active
( powered ) Pickup Systems of all types are least
affected, but are not unaffected by lead length and
quality. A maximum of 10m ( 33') is recommended. For
lengths above that, go to balanced cables, such as XLR
outputs from Active D.I Boxes, e.g EDB-2 H.E
3.1.3 D.I. BALANCED LEADS: XLR Output leads
running a Balanced signal greatly extend effective lead
lengths possible without noise build up, making cable
quality less critical for noise
4.0 CH.1. JACK INPUT ( Standard 1/4" - 6.35mm diam.)
- LOCATED ON FRONT END. Accepts Active and
P.25
To Next Page
Loading...