the tip of jack (red or white wire in stereo cable) feeds
Channel 2. The signal on the ring of the jack (blue or
black wire in cable) feeds Channel 1.
Plugging a Mono Plug into the Stereo In feeds Ch.2 only,
freeing Ch.1 for additional Independent use
Warning - Plugging a live Power Amp would likely
damage the unit and negate the Guarantee / Warranty
Headway Music Audio will NOT accept requests for
information on other manufacturers wiring or
specifications
Headway Music Audio Ltd. will not be held liable for
damage to other manufacturers pickup systems from
Phantom Power
The Ring Position suits more typical active pickup
systems where wired for Phantom Power. Tip position
powering is required for many Electret Condenser Mic
based systems
8.1.2 MIC INPUT XLR: Impedance < 2k Ohm.
XLR input accepts Dynamic, Ribbon, Condenser and
Electret Condenser Microphones
The XLR input allows the use of a high quality true
Condenser Mic or Ribbon MIc, directed at the instrument,
often to be mixed in combination with a pickup source fed
into Channel 1
P.36
To Next Page
Loading...