The smaller alternative Pre-amplifier EDM-1 H.E will
run on Phantom Power from most mixers, depending
upon the voltage and milli-amps offered, as current
draw is much lower, due to reduced functions
Applying Phantom from a Mixer to EDB-2 H.E will
NOT damage the unit
10. NOTCH FILTER CONTROLS / ANTI-FEEDBACK -
LOCATED ON TOP
Sometimes known as a "Sweep" the Notch Filter utilises
two Rotary Pot Controls, a Sliding On/Off Switch and a
sliding channel selector Switch. It applies either to
Channels 1 or 2 and applies to Line out and DI out
P.43
To Next Page
Loading...