Allows control of the bass at the lowest frequency of the
audio spectrum and will over-lap a little tonally with Low
Mid control
Controls the lowest frequency of the audio spectrum
Cut Bass ACW to cut body handling noise, boomy
sounds, externally generated hum, percussive clunks and
low end feedback, as well as any instrument bias towards
the low strings.
Increase Bass CW to beef-up tone or bias lower strings
more strongly. However, high strings will produce some
lower tones or sub-harmonics which will be enhanced or
reduced by the Bass Control
If you prefer a more sharply focussed Bass cut, use the
Notch Filter
Guitar or Violin 'Range" setting offers a fairly gentle
additional bass roll off
ii) LOW MID CONTROL: +/- 12dB centred broadly,
approximately @ 590Hz
With a broad sweep it allows control of lower Middle
range of frequency spectrum which is centred above
bass but below High Mid or Treble/High. These will
overlap on both sides a little
Cut Low Mid ACW bringing down to thin out tone or
linearise or naturalise the tone of many lower mid biased
guitar pickups, especially when mounted on steel strung
Acoustic guitars
Also, used in cut mode, to linearise speakers and
speaker cabinets which are often Mid biased
P.31
To Next Page
Loading...