headway EDB-2 H.E - Electrical Specifications Overview

• Weight of Retail Packaging complete with EDB-2
H.E = g (. " )
• Mic Stand Bracket Connector: Female threaded
bush on rear at 19/32" = 15mm approx.). DO NOT
OVER TIGHTEN!
19.2 ELECTRICAL SPECIFICATIONS (Approx.)
19.2.1 CH.1 & CH.2 Jack Input Impedance = 6.8Meg
Ohms / High Impedance
Voicing is not negatively affected by Impedance setting
when using Active Inputs & Condenser Mic's etc. and will
optimise Piezos and slightly brighten dull sounding
Passive Magnetic Pickups & Dynamic Mic's
• Gain Control to Ch.1 Jack: Continuously variable 0
- +32dB Jack IN: Offers Mono Signal path IN via
Tip plus Phantom Power 11v option, sent when
switched on via Ring or Tip Switching Options
• Gain Control to Ch.2 Jack: Continuously variable 0
- +32dB Jack IN: Offers Mono to Ring ( Ch.2 ) or
Stereo Signal path IN via Tip to Ch.2 & Ring to
Ch.1
• Ch.2 XLR Mic In with Continuously variable 0 -
+50dB and Switchable Phantom Power 11v -48v
option. Ch.2 XLR Mic Input Impedance = 3.4kOhm
19.2.2 BAXENDALL INTERACTIVE 3 BAND EQ
SECTION
P.57