noise levels building up, so pedals with the highest output
and lowest noise ( s/n ) should be first in the chain. You
may wish to experiment with the order FX Pedals are
connected as this will also affect tones and the way they
interact with each other
Devices chained into the Loop may include Chorus,
Delay, Reverb, Acoustic Multi FX, Band Creator Pedal,
Phaser, Vibrato, Volume Pedals, Electronic Tuners with
Jack In and Out, or Pro Audio type Compressor/Limiter
We do not recommend Electric Guitar type Compressor
Pedals or Overdrive/Distortion Pedals for Acoustic
Instruments if you wish to retain an acoustic sound
Headway Music Audio Ltd. recommends that Jacks
Socket contacts be kept clean to retain full working
operation. Lubricating with e.g. Switch Cleaner with
Lubricant, or WD40 will prevent problems. Send & Return
Sockets should treated with particular care
14. AUX IN / IPod - LOCATED ON RIGHT SIDE - 3.5mm
Diam. Mini-Jack Socket routes directly to Master Volume
Pot (Post EQ )
Intended to connect analogue audio signal of pre-
recorded music for practice or backing, which does not
require EQ
15. MASTER VOLUME CONTROL - LOCATED ON TOP
Rotary Pot Control sets the output level of the EDB-2 H.E
pre amp which is fed to the LINE OUT and DI Out
sockets
P.51
To Next Page
Loading...