headway EDB-2 H.E - Page 41

9.1 3 WAY PHANTOM SWITCH to CH.1 IN JACK
SOCKET:
OFF / 11V to JACK RING / 11v to JACK TIP
This is not to be confused with the XLR On/Off Switch on
the top, which switches off the XLR circuitry
EDB-2 H.E Phantom provision enables external powering
of certain Active Pickup Systems and Blender systems on
board instruments with no battery inside where wired to
accept Phantom Power via RING (Stereo Jack Lead) or
wired to accept Phantom Power to TIP.
Active Pickup or Active Pickup/Mic Blender Systems
wired for Phantom should NOT require an Internal
Battery. This may be an advantage where maximum
active system performance is required but where battery
access may be restricted, e.g. "f" Hole Instruments and
Resophonic Guitars
When using Phantom Power, we recommend removing
any battery in place in a pickup system, whether new or
expired, which might be heated up or be damaged and
leak. You may then need to bridge the two battery snap
terminals with a wire from positive to negative to
complete the circuit
Headway's "HE4" and "Snake3" Active Pickups may be
powered by 9v-18v Phantom Power to RING from EDB-2
H.E, using a Stereo Jack Lead to End Pin Jack Socket.
ENABLE PHANTOM POWER BY REMOVING BATTERY
AND CONNECTING THE TWO BATTERY TERMINALS
TOGETHER. Alternatively use Headway's "PPE Clip"
(Phantom Power Enabler) which is fast and reversible
and available to HE4 & Snake3 Purchasers
P.41