Page
44
1
Refer to Pictorial
4-8
for the following steps.
Connect the wires coming from the component side of the
circuit board as follows:
NOTE: In the following step, if solder on the bare end of
the red wire prevents its entry into hole D, carefully cut off
1
just enough of the soldered wire end to allow
it
to fit into
Wire From
Connect
to
the hole. Be careful not to cut the wire too short.
Color Hole
(4
Connect the red wire coming from the HV transformer
(d,
HVY Blue
J
Solder lug CK
(S-2).
to hole D on the circuit board
6-1).
Reach in between
(
4
yellow
F
Lug
3
of meter switch
6-11.
the circuit board and the capacitor bracket to solder
this connection. Make sure this connection is well
soldered.
(
/'
Orange G Lug
1
of meter switch
6-1).
(
6
Pass one lead of
a
.001
eF,
6
kV, capacitor through
(J)
Black C
solder lug CF
6-21
to hole
K
in the circuit board
(
J)
Red
(S-1).
Connect the other lead of this capacitor to
A
Lug
2
of plate meter
(S-2).
Lug
1
of plate meter
6-2).
solder lug CK
(NS).
(4
Insert the black stranded wire coming from hole
E
in
the circuit board down through grommet AL.
(4
Peel off the backing paper from the DANGER label
and press
it
into place on the top of the capacitor
Refer to the inset drawing of Pictorial
4-8
and Detail
4-8A
bank bracket.
for the next two steps.
(
J
Connect the black cathode wire, coming from the
solder lug of zener diode
CW,
to the foil side of the
circuit board
6-1).
Detail
4-8A
shows the foil pattern.
(4)
Connect the other black wire, coming from the anode
of zener diode
CW,
to the foil side of the circuit board
(S-1).
Refer to Detail
4-8A
for the foil configuration.
FROM
ZENER DIODE
CATHODE ANODE
ZENER DIODE
SOLDER
LUG
-
(viewed
from foil
side)
A
Detail
4-8A
To Next Page
Loading...
