Page 46
UNDER-CHASSIS WIRING
Refer to Pictorial 49 and cut the transformer leads coming
through the chassis
at
Y, AH and AK to the indicated
lengths. Be sure you have selected the proper location before
you cut. Measure the length of each lead from the chassis.
(4
At grommet
Y,
cut the transformer leads as follows:
blue 4112"
Yellow 9-1 12"
Black 41 12"
Black-red 9-1 12"
Black-Yellow 9-1 12"
Black-Green 4-314"
(4"
At
grommet AH, cut the transformer leads as follows:
Green 6-1 12"
Green-Yellow 7-114"
Green 5-314"
(
J
1
At grommet AK, cut the transformer leads as follows:
One red 4-1 12"
Other red 4"
Black-Red 3-314"
Black-Yellow 3-314"
Black 3-1 12"
Black-Green Do not cut
i
i
1
NOTE: When you remove insulation from transformer leads
I
in the following steps, grasp the wires where they emerge
from the chassis so no strain will be placed on the
connections at the transformer end of the leads.
PICTORIAL
4-9
Remove 114" of insulation from the cut ends of the
two heavy green leads coming from AH. Melt a=
amount of solder on the bared wire ends.
(dl
Remove 114" of insulation from the end of each
remaining transformer lead. Twist the fine wire strands
together and melt a
small
amount of solder on each
bared end.
To Next Page
Loading...
