;
@+)*---~=:--dJ
Page
47
Detail 4-9A
(4)
Refer to Detail
4-9A
and form a
#10
double lug
(#259-25)
as shown.
(d'
Refer to Detail 4-96 and screw
a
6-32
x
314"
tapped
phenolic spacer onto screw AW. Then install the
formed lug on the inner end of the phenolic spacer
with a
6-32
x
114"
screw. Position the lug as shown.
Detail 4-10A
Refer to Pictorial
4-10
(fold-out from
Page
49)
for the
6-32
x
114"
SCREW
following steps.
/
(
Route the twisted green and brown wires from
FORMED
#lo
grommet AL between grommet AH and grommet AK.
DOUBLE
LUG
Refer to Detail 4-10A and connect one of the brown
wires to lug
1
(NS)
and the other brown wire to lug
3
(NS)
of terminal strip
P.
6-32
x
314"
TAPPED
PHENOLIC SPACER
(
6-
Connect a
.02
pF
disc capacitor from lug
1 (NSI
to lug
2 (NS)
of terminal strip P.
Connect a
.02
,uF
disc capacitor from lug
3 (NS)
to lug
2 (S-2)
of terminal strip P.
(
Connect the green wire from grommet AL to lug
1
of
terminal strip B
(NS).
Detail
48B
Connect the transformer leads from grommet AK as follows:
NOTE: Before starting the wiring in the following steps,
look ahead to the under-chassis photograph on Page
86.
Lead
Connect
to
Observe how wires are routed down the center of the chassis
and are then bound together by ties to form a cable. As an
(
\/j
4-112"
Red
Terminal strip BT, lug
3 (NS).
aid in forming a neat cable, you can mark the main wiring
guide lines on the under side of the chassis with a magic
(d
4"
Red
Terminal strip BT, lug
4 (NS).
marker or china marking pencil. Then follow these guide
/
lines when routing the individual wires.
(
4)
Blackgreen Terminal strip AE, lug
3 (NS).
To Next Page
Loading...
